PR Lighting PR-2226, Manual

Page: 4 / 22

4/22
INSTALL THE PROJECTOR
Take 2 clamps and the safety cord out from the package and mount 2 clamps on the underside of fixture with 2 retainers
attached to each clamp. Hang the fixture on the structure and fasten the screws attached to each clamp. (See the
WARNING
on the underside of the base as shown above)
To pass SAFETY CORD through 2 HOLES for safety!
Always ensure that the projector is firmly anchored to avoid vibration and slipping whilst functioning. Always ensure that
the structure that you are going to mount the projector is secure and is strong enough to support a weight of XS 250.
WARNING:
1. Unlock the PAN and TILT before the 1
st
application of projector for safety.
2. The projector MUST be lifted or carried by the HANDLES instead of clamps.
3. For safety the safety cord should afford 10 times of the unit’s weight.
FITTING THE LAMP
Lock the yoke before fitting/replacing the lamp.
Open the cover board at the rear of the projector by loosening 3 screws, you can see the structure as shown in the figure
above.
Gently pull out lamp holder assembly.
Take out the worn-out lamp. Insert the new lamp to the socket.
Note:
don’t touch the bulb of the new lamp with bare
hand so as not to influence the beam output.
Close the rear cover and fasten 3 screws.
WARNING: The MSD series are high-pressure lamps with external igniters ( ). Care should always be taken
when handling these lamps. Always read the manufacturers "Instructions for use" enclosed with the lamp.