.01.
If the device has been exposed to temperature changes due to environmental changes,
do not switch it on immediately. The arising condensation could damage the device.
Leave the device switched off until it has reached room temperature.
This device falls under protection-class I. Therefore it is essential that the device be
earthed.
The electric connection must carr y out by qualified person.
The device shall only be used with rate voltage and frequency.
Make sure that the available voltage is not higher than stated at the end of this manual.
Make sure the power cord is never crimped or damaged by sharp edges. If this would
be the case, replacement of the cable must be done by an authorized dealer.
Always disconnect from the mains, when the device is not in use or before cleaning it.
Only handle the power cord by the plug. Never pull out the plug by tugging the power
cord.
During initial start-up some smoke or smell may arise. This is a normal process and
does not necessarily mean that the device is defective, it should decrease gradually.
Please don't project the beam onto combustible substances.
Fixtures cannot be installed on combustible substances, keep more than 50cm
distance with wall for smooth air flow, so there should be no shelter for fans and
ventilation for heat radiation.
If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively
replaced by the manufacturer or his ser vice agent or a similar qualified person in order
to avoid a hazard.
This device has left the factor y in perfect condition. In order to maintain this
condition and to ensure a safe operation, it is absolutely necessar y for the user to
follow the safety instructions and warning notes written in this user manual.
CAU T I O N
Becareful with your operations.With a dangerous voltage you cansuffer a
dangerous electric shock when touching wires!
IMPORTANT
Damages caused by the disregard of this user manual are not subject to warranty.
The dealer will not accept liability for any resulting defects or problems.
SAFETY INSTRUCTIONS
1
.10.
Speed control (in Static colors/Color jumping)
0-100% Linear dimmer
Static colors select
Speed control of jumping/fading;
Sensitivity control of sound control
Dimmer mode/Strobe mode
Static color mode
Color jumping mode
Color fading mode
Sound mode
0-255
0-255
0-255
0-255
0-59
60-119
120-179
180-239
240-255
Static Colors/
Color Jumping
CH8 (60-179)
Dimmer Mode
/Strobe Mode
CH8(0-59)
Static Color Mode
CH8(60-119)
Color Jumping Mode
/Color Fading Mode
/Sound ModeCH8
(120-255)
Mode
7
8
