7
controller. The Unit has 1 DMX mode. For example standard mode has 9
c
hannels, so set the No. 1 projector’s address 001, No. 2
projector’s address 010, No. 3 projector’s address 019, No. 4 projector’s address028, and so on.
Launch the projector. Press button ENTER more than 3seconds to unlock panel.
Press button ENTER to display DMX address;
Press button UP and DOWN, you can set the address;
Press button ENTER to confirm; after powered on next time, the default will be last value saved
Press button FUNC, it will return to the upper menu
If DMX signal is available, LED indication is on. Otherwise it is off.
●WIRELESS CONTROL OPERATION
The optional version of the projector has wireless control function with DMX wireless receiver module and DMX wireless antenna
for remote control.
The operation details are as follows:
1. Enter into the menu, then enter into “Config Set” after
UP or DOWN is pushed;
2.Select “Wireless mode”
－
→”Wireless first”(Note: do not select” XLR only); Then the wireless control is activated. Only
after the project and wireless transmitter are connected, can the it receive wireless signal. If wireless control is deactivated,
press “Yes” under “Unlink wireless” under “config Set”. Then the projector will disconnect wit the wireless transmitter.
●
STAND-ALONE MODE
Operate the projector without connecting with a controller, enable the master mode through the operation panel, the
projector will run in Stand-Alone mode automatically.
DMX address can be set at any number within 512
.
●
MASTER/SLAVE MODE
Many projectors can run synchronously in the Master/Slave mode by linking them with each other. First,
connect the first fixture’s DMX output to the second fixture’s DMX input using XLR-XLR control cable and then connect the second
fixture’s DMX output to the third fixture’s DMX input, and so on until all projector are connected in this way. Eventually connect the
last fixture’s DMX output to a DMX terminator. Set 1
st
projector as the master and others are Slaves.
Start Addresses of all Slaves are 001; Operation mode of the Master can be set any mode for a Master’ and Slaves’ operation mode can
be set accordingly
After Powered on, the group will run in Master/Slave Mode
Slave
Master
Slave
DMX OUT
DMX IN
DMX OUT
DMX IN
DMX Teminator
