10
All terrain mini hauler
Fill tank to no more than 12.5mm (1/2” )
below the bottom of the filler neck to
provide space for expansion.
mini hauler Operation
Adding fuel
Fill the fuel tank as instructed in the separate
Engine Manual
packed with the machine.
Starting engine
A more detailed description of the engine operation
and all related precautions and procedures can be
found in the
Engine Manual
packed separately
with the mini hauler.
Follow the procedure below for cold starts:
Turn choke lever on the engine to full choke
position.
Set the throttle lever on the handlebar at half-
way position.
Turn the engine switch on.
Pull the starting rope slowly several times to
allow the gasoline to flow into the engine’s
carburetor. Then hold the start handle firmly
and pull rope out a short distance until you
feel some resistance. Then pull the rope
smoothly and briskly, and allow rope to return
gently. Do not let the rope snap back. If
necessary, pull the rope several times until the
engine starts.
5. Allow the engine to run for several seconds to
warm up. Then, gradually move chock lever to
“ OPEN” position.
Restarting an engine that is already warm from
previous running does not normally require use of
the choke.
1.
2.
3.
4.
Tipping handle
It controls tipping of the dump box. Pull the tipping
handle up to release the dump box's locking device
and raise the dump box. Pull the tipping handle
down to its original position. When the dump box
is lowered, the locking mechanism operates, locking
the dump box. To check whether the dump box
is locked securely, try to lift it without pulling up
the tipping handle.
Set the throttle lever on the handlebar at half-
way position.
2. Hold the start handle firmly and pull rope out
a short distance until you feel some resistance.
Then pull the rope smoothly and briskly, and
allow rope to return gently. Do not let the rope
snap back.
Operating
After engine warms up, pull throttle lever to
accelerate engine speed.
Engage the required gear and slowly squeeze the
clutch control lever. If the gear does not engage
straight away, slowly release the clutch lever and
try again. In this way the mini hauler will start
moving.
The mini hauler has the steering levers on the
handlebars and this makes steering very easy. To
turn right or left, simply operate the corresponding
right or left steering lever.
The sensitivity of the steering increases in
proportion to the speed of the machine and that
with the empty machine, a light pressure on the
lever is all that is needed to turn. While when the
machine is loaded, more pressure is required.
The mini hauler has a maximum capacity of
300kg. However, it is advisable to assess the load
and adjust it according to the ground on which
the machine will be used.
It is therefore advisable to cover such stretches
using low gear and taking extra care. In such
situations, the machine should be kept in low gear
for the whole stretch.
Avoid sharp turns and frequent changes of
direction while driving on the road, in particularly
on rough, hard terrains full of sharp, uneven points
with a high degree of friction.
Even though the unit has rubber tracks, remember
to be careful when working in adverse weather
conditions (ice, heavy rain and snow) or on types
of ground that could make the mini hauler
unstable.
Please note that as this is a tracked vehicle, it is
subject to a considerable pitching movement when
passing over bumps, holes and steps.
When the clutch control lever is released, the
machine will stop and brake automatically.
1.
