8
OPTIONAL: USING A PRESSURE WASHER ATTACHMENT (Not Included)
OPTIONAL: CLEANING CARPET WITH A CARPET WAND (Not Included)
MAINTENANCE
DRAINING RECOVERY TANK
OPTIONAL: DRYING YOUR FLOOR WITH A SQUEEGEE TOOL (Not Included)
1. Verify the vacuum hose and solution hose are securely connected to the machine and carpet
wand.
2. Set the PSI to no more than 800 psi to clean carpet.
CAUTION
: Damage to carpet may occur
if the PSI is set too high.
3. When finished with the job, shut off all switches. Before disconnecting solution hose, relieve
the water pressure from the carpet wand by holding the trigger on the carpet wand.
1. Verify the vacuum hose and solution hose are securely connected to the machine and
pressure washer spray wand.
2. Set the PSI to the desired pressure between 400-1200 PSI.
3. When finished with the job, shut off all switches. Before disconnecting solution hose, relieve
the water pressure from the pressure washer spray wand by holding the trigger on the pressure
washer spray wand.
WARNING!
TO AVOID SERIOUS INJURY, NEVER POINT SPRAY NOZZLE
AT YOURSELF, OTHER PERSONS OR ANIMALS!
1. Verify the vacuum hose is securely connected to the machine and wand. Connect the
squeegee tool to the wand.
2. Turn on the vacuum switch to vacuum excess water.
1. Turn off all switches.
2. Drain the recovery tank by holding the end of the drain hose with the cap above the machine.
Remove the cap on the drain hose. Lower the drain hose over a drain or a bucket to drain the
recovery tank.
Note:
When using the auto dump feature, the recovery tank must be rinsed and then drained
with the drain hose after each use.
To keep the machine in good working condition, maintenance procedures should be followed
after each use.
CAUTION
: When servicing machine turn the power off and unplug the machine from the wall
outlet.
1. Drain and flush the recovery tank, intake hoses, and any wand or hand tool used with clean
water. Make sure the discharge connector is closed.
2. Thoroughly clean the inlet basket filter.
3. Inspect power cords for damage. Replace damaged cords and plugs immediately. Do not use
the machine with a damaged cord or plug.
GENERAL INSTRUCTIONS
