7
Squeegee:
Every week, check the blades of the squeegee and wash them carefully. Then replace
them in the correct working position. If drying is not perfect even after the unit has been cleaned,
replace any blades which are excessively worn. If the squeegee does not pick up enough water
or streaks, lift and wipe off the blades.
Pad Driver:
The pad driver or brush must be in good working condition because it is the
component which removes the dirt. To remove the brush/ pad driver from the machine: •
Depress the brush pedal (M9) to lift the brush. • With the brush in the air depress the handle
(M10) to rotate the brush.
• Release the handle and the brush will release from the machine and fall to the floor. To replace
the drive block, pad or brush: • Center the brush/pad driver under the front of the machine. •
Release the brush pedal (M9) to lower the brush drive motor on to the brush/pad driver. • Turn
the brush motor on by depressing the brush switch (M7). The brush/pad driver should lock in
place. • If the brush/pad driver does not connect, small adjustments are needed from one side
to the other to make the brush/pad driver lock in place. Brushes in tynex, poly and steel are
available on request, together with floor pads recommended for use with the pad driver. Black
for stripping, green for deep scrub, blue for cleansing and red for light scrub.
Water collection tank:
This tank should be cleaned every week. Lift the lid and remove the panel
or funnel M1 of the solution tank. Remove the strap M13 and lift the vacuum motor out of its
seat. Thoroughly clean the filter and wash out the dirt deposited in the tank with a jet of water,
allowing it to drain out through hose M2. If necessary, replace filter. Replace float cage with open
side facing front of scrubber.
M1
M2
M10
M13
M9
