5
H
oW
t
o
a
ssemble
t
He
p
ad
Always unplug the machine before installing any accessory.
1. Unplug machine, secure handle tube in vertical position and lay down the machine turning it
over its wheels until the underneath side of the machine is vertical and fully exposed.
2. Before laying down machine, place a clean towel on the floor to keep the switch box from
scratching.
3. Install or replace pad. The pad should be replaced if it has become matted down to a
thickness of 3/8” or less.
4. Remove existing pad then center new pad over grip face. Press pad against grip face until the
hooks in the driver have set in the pad.
5. Return the machine to the upright position.
6. Do not operate this machine with out the pad in place.
H
oW
t
o
s
taRt
Y
oUR
f
looR
m
acHIne
1. Plug the power cord into a proper grounded outlet.
2. Adjust handle tube in a comfortable position by loosening the adjusting lever at the desired
height.
3. Press Switch lock and at the same time, press the starting switch on the handle grip. The
motor will start.
WARNING
: The chassis should be parallel to the floor when you turn the
machine on. It is recommended to familiarize with the machine by working on large spaces
until you gain experience with the machine.
4. To turn the machine off simply release the starting switch while keeping hands on handle grip.
H
oW
t
o
R
eplace
I
solatoRs
The unit works with 4 isolators that reduce the vibration of the floor machine during operation.
If the unit vibrates or makes more noise than usual, then the replacement of the isolators may
be necessary.
To replace them follow these instructions:
1. Always unplug the machine before replacing any part.
2. Follow instructions 1 & 2 on how to assemble the pad.
3. Remove the central part of the grip face pulling it off the pad driver.
4. Remove the central screw on the bottom of the pad driver with a 3/4 wrench (Fig.1).
Note: To unscrew the central screw, you can use a screw driver to block the fan on top of the
motor (Fig. 2) this will hold the screw from spinning.
5. Remove the screws that hold the pad driver with the chassis, 4 screws (Fig. 3)
6. Unscrew the isolators and replace with new ones, 4 isolators (Fig. 4)
7. Follow the same instructions in reverse to reassemble the unit.
1
2
3
4
Fig.1
Fig.2
Fig.3
Fig.4
