Powerwerks PW100BT, User Manual

Page: 8 / 12

Output Power 1% 50W 8 Ohm load
Channels 1 and 2
Channel 3 Mic XLR Balanced, Line level 1/4" Un-balanced
-65dB Residual Noise, all level controls 0% (minimum)
-48dB Nominal System Noise, all level controls at 50%
+70dB Mic to Speaker Output (CH 1 & 2)
+56dB Line to Speaker Output (CH 1 & 2)
+42dB AUX IN to Speaker Output
Channel EQ (high, low)
Subwoofer Out Line Out 20Hz-150Hz.
Phantom Power +15V Mic inputs (Ch 1 & 2)
USA/Canada 120VAC/60Hz, 80W nominal
Europe
UK 230VAC/50Hz, 80W nominal
230VAC/50Hz, 80W nominal
Australia 240VAC/50Hz, 80W nominal
Japan 100VAC/50-60Hz, 80W nominal
Speakers Two 4½" 50W 4 Ohm each
Horn 20mm Titanium Dome Tweeter
Power Capacity 50W RMS
60HZ-20kHz Full range (subwoofer jack not used)
150HZ-20kHz Crossover Active (1/4" mono plug in subwoofer jack)
Nominal Impedance 8 Ohms Not designed for external speakers
mm/kg 190 W x 460 H x 165 D / 6.7 kg
Inches/Pounds 7.5 W x 18 H x 6.5 D / 14.7 lb
Dimensions & Weight
Bluetooth Module Features
Bluetooth 3.0+EDR compliant.T2dBm Class 2 output power.
Audio DAC:94dB SNR.A2DP profile support.
PW50BT Powered PA Specifications
4kHz and above , 800Hz and below.
Power Requirements
POWERLINK (IN and OUT)
Both jacks accept a balanced input and sends a pre-master volume output mix of
channels. Recommended use: Linking two PW50BT units together.
System Gain
(Measurements made at 1kHz)
Frequency Response 20HZ-20kHz
Accepted Inputs
Hum & Noise
Frequency Response
Actual response is tailored to speaker cabinet for
accurate acoustical response.