PowerWalker VI 1100 CW, Quick Manual

Page: 5 / 50

ENGLISH
Site wiring fault
Sounding every 2 seconds
No
EPO enabled
Sounding every 2 seconds
No
Over temperature
(Error 41)
Sounding every 2 seconds
No
Charger failure
(Error 45)
Sounding every 2 seconds
No
Battery fault
Sounding every 2 seconds
(UPS remains off to
enforce the battery
check)
No
Battery replacement
Sounding every 2 seconds
No
EEPROM error
Sounding every 2 seconds
No
VI. Button operation
ON/Mute Button
• Press and hold ON/Mute button for at least 2 seconds to turn on the UPS.
• When the UPS is on battery mode, press and hold this button for at least 3 seconds to
disable or enable the alarm system. But it’s not applied to the situations when warnings
or errors occur.
•
Press this button to display previous selection in UPS setting mode (up key)
• Press and hold ON/Mute button for 3 seconds to enter UPS self-testing while in AC
mode, ECO mode, or converter mode.
OFF/Enter Button
• Press and hold this button at least 2 seconds to turn off the UPS. UPS will be in standby
mode under power normal or transfer to “Bypass” mode if the “Bypass enabled” setting
is activated.
• Press this button to confirm selection in UPS setting mode.
Select Button
•
Press this button to change the LCD message for input voltage, input frequency, battery
voltage, output voltage and output frequency.
• Press and hold this button for 3 seconds to enter UPS setting mode when UPS is in
standby mode or “bypass” mode.
• Press this button to display next selection in UPS setting mode. (down key)
ON/Mute + Select Button
•
When the input power is normal, press the two buttons simultaneously for 3 seconds.
Then UPS will enter to the „bypass” mode. This action will be ineffective when the input
voltage is out of acceptable range.
• In setting mode, press the two buttons simultaneously for 0.2s to exit the setting mode.