PowerWalker 10122192, User Manual

Page: 24 / 122

19
4.3 Display functions
When starting the UPS, the display is in the default UPS status summary screen.
Main menu Submenu Display information or Menu function
UPS status
UPS mode, IoT status, date/time, battery status and
current alarms
Event log Displays the events and faults stored
Measurements
[Load] W VA A P%, [Input/Output] V Hz,
[Battery] % min V EBM, [DC Bus] V, [Temperature] C
Control
Go to Bypass Transfers the UPS on Bypass mode
Load segment Load segment on/off
Start battery test Starts a manual battery test
Reset fault state Clear active fault
Reset event list Clear events and faults
Reset com card Reset com card inside UPS
Restore factory settings Restore to default factory settings
Settings Refer to chapter 4.4 User settings
Identification
[Product name], [Serial number], [firmware
version], [IP/MAC address]
4.4 User settings
Submenu Available settings Default settings
Password Can be changed by user 4732
Change language
English, Italiano, Français, Deutsch, Español,
Русский, Polski,
简体中文
English
User password [enabled, ****], [disabled] enabled
Audible alarms [enabled], [disabled] enabled
Output voltage [200V], [208V], [220V], [230V], [240V]
[230V]
[240V] for AU
Output frequency [autosensing], [converter 50Hz, 60Hz] autosensing
High efficiency mode [disabled], [enabled] disabled
Auto bypass [disabled], [enabled] disabled
Start/Auto restart/Start
from bypass
[disabled], [enabled]
Cold start/Auto restart:
enabled
Start from bypass:
disabled
Site wiring fault [enabled], [disabled] disabled