PowerTrainer PT-333, Owner'S Manual

Page: 11 / 23

11
ASSEMBLY INSTRUCTION (CONT’D)
7. If the running belt tracks off center to
the right or left deck
a. Turn the power off
b. Use a 6mm wrench to tighten the
rear roller bolt on the side of the
treadmill toward which the belt is
moving as shown.
c. Tighten about 1/4 of turn
(clockwise).
Note: If the belt does not move
back to the center of the treadmill,
make another adjustment to the
same bolt.
Once the running belt has been
adjusted closer to the center, the
treadmill can be powered on again.
8. This treadmill is foldable for easy
storage.
Note
：
Disconnect all power before
folding.
Folding:
a. Lift the deck by holding the end
caps.
b. Make sure the retaining shaft is
locked by the unfolding pedal.
Unfolding:
a. Hold the end caps with both
hands.
b. Step on the unfolding pedal.
Lower the deck down gently with
your hands until the deck is on the
floor.
To move the treadmill, the treadmill
should be at the folded upright position.
Hold the end caps tightly and push the
deck down slowly until the casters can be
moved.
Rear Roller Bolt
6 mm wrench
End Cap
Unfolding Pedal
Retaining Shaft
For example, if the belt moves to the left and the deck becomes
exposed on the right, tighten the bolt on the left side of the frame.
Casters