PowerTec UT1004, Owner'S Manual

Page: 6 / 12

OPERATION
4
WARNING
Do not use the ultra-work stand for scaffolding or as a
ladder. Make sure to securely tighten all fasteners before
using. Maximum capacity is 330 lbs. (150 kg). Power tools
on the ultra-work stand should not exceed a combined
overall height of 60" (152.4 cm) from the floor.
ROLLER BAR/EXTENSION BAR
ADJUSTMENT
Refer to Figure 7
The extension bars move in and out to properly support
the workpiece.
The roller bars are used as directional rollers or with the
extension bars as stationary stop guides.
• Loosen the locking knobs and slide the extension bar in
or out to desired position and tighten the locking knobs.
Figure 7
Roller Bar
Locking
Knob
Extension Bar
Sping Pin
Leg
Preset
Holes
Locking
Knob
Locking Knob
Leg Release
Spring Pin
GENERAL MAINTENANCE
WARNING
When servicing, use only identical replacement parts. Use
of any other parts may create a hazard or cause product
damage. To ensure safety and reliability, all repairs
should be performed by a qualified service technician.
MAINTENANCE
4
MAINTENANCE 4
WARNING
Keep the ultra-work stand dry, clean, and free from oil and
grease. Always use a clean cloth when cleaning. Never
use brake fluids, gasoline, petroleum based products
or any strong solvent to clean the ultra-work stand.
Chemicals can damage, weaken or destroy plastic which
may result in serious personal injury.
OPERATION
4
• Loosen the locking knobs, slide the roller bars up and
down to desired location, tighten the large locking
knobs.
LEG ADJUSTMENT
Refer to Figure 7
To adjust the legs:
• Determine the work height needed based on the tool
being used.
• Depress the spring pin on the leg and slide the leg up or
down to the desired height. Release the spring pin into
one of the six preset holes on the leg. Repeat on other
three legs.
TRANSPORTATION/STORAGE
Refer to Figure 7, 8
• Depress the leg release spring pins and fold up the legs.
The legs will lock into place.
• Lift the ultra work stand by the handle.
Figure 8
Handle