The recommended method
is to fix a wooden panel within the
cabinet at a distance of 15mm below
the underside of the hob (Fig. 6).
This panel must have adequate ventilation to the rear
.
Unit: mm
NOTE:
The panel underneath the hob must be easily removable to allow for any servicing requirements.
INSERTING AND FIXING THE HOB
INSTALLATION OPTIONS
Detach the seals from their backing ensuring that the transparent protection still adheres to the seal.
Turn the hob over and correctly position seal *S* (Fig. 5) under the edge of the hob so that the outer
part of the seal perfectly matches the outer edge of the hob. The ends of the strips must fit together
without overlapping. Fix the seal to the hob evenly and securely, pressing it firmly in place.
Ventilation slot ≥ 30mm.
15mm MIN.
Fig. 6
Fig. 7
Worktop
Fixing bracket
Screw
3.5cm
S
4cm
S
Worktop
Fixing bracket
Screw
In the case of built-in hotplates, where the manufacturer specifies that a horizontal separation shall be
included below the base of the hotplate, the critical dimensions of this separation. In addition, the
minimum distance declared shall not exceed 150mm;
Prolonged intensive use of the appliance may call for additional ventilation, for example opening of a
window or more effective ventilation, for example increasing the level of machanical ventilation where
present.
CAUTION:
Accessible parts may be hot when the grill is in use. Young children should be kept away.
CAUTION:
This appliance is for cooking purposes only. It must not be used for other purposes, for
example room heating.
When fitting a gas hob above a drawer or a standard housing unit, suitable precautions must be
taken to prevent contact with the hotplate surface as it can become very hot during operation.
Before inserting the hob into the work surface, please follow the below instructions:
1) Remove the pan stands and burner caps before turning the hob upside down, taking care not to
damage the ignition plugs and thermocouples.
2) Place the seal “S” around the bottom edge of the hob as shown in the illustration below.
3) Place the hob in the installation opening and push it down so that the hob is resting firmly on the
worktop.
4) Secure the hob in position using the fixing brackets supplied. Screw one end of the bracket into the
pre-drilled holes in the underside of the hob. The other end of the bracket should be located
underneath the worktop to secure the hob in position.
Fig. 5
S
S
Rear wall should be a flame retardant material
Fig. 4
D
D
A
B
E
F
G
Front edge of worktop
C
F
G
400 650min
A B
C
D
E
557 477 50min 150min 90min
4
