7
If inserting into a cabinet there must be clearance of 9 cm at the back of
the Freezer and 2cm at the side.
The minimum distance between the top of the cabinet and the wall unit
must be at least 100 mm .
The power cord must not be lengthened. Ensure that the power plug is
not squashed or damaged by the back of the appliance. A damaged
Power plug may overheat and cause a fire.
Insert the plug into the wall socket and switch on the electricity supply.
You will hear a noise as the compressor starts up. The liquid and gases
sealed within the refrigeration system may also give rise to noise
Whether the compressor is running or not which is quite normal.
Set the thermostat to “3” and close the door. After 30 minutes you should
observe a drop in temperature.
Front edges of the cabinet may feel warm. This is normal.
Do not load the appliance immediately it is switched on. Wait until the
correct storage temperature has been reached. We recommend that the
temperature be checked with an accurate thermometer or wait 24 hours.
To turn off the appliance, turn the temperature regulator to the "Dot
Symbol" position.
“4” on the thermostat represents the lowest temperature.
Before Use Check That:
The interior is dry and air can circulate freely at the rear of the cabinet.
Interior is cleaned as recommended under "Cleaning and Care".
USING YOUR FREEZER
Summary of Contents for P125FMDW
Page 3: ...3 PRODUCT OVERVIEW ...