POWXQ5406
EN
Copyright © 2015 VARO
P a g e
|
6
www.varo.com
Release the on/off switch
To switch off :
press the on/off switch once to release the lock on button
Attention: The sanding belt is not suitable for wet sanding jobs
9 CLEANING AND MAINTENANCE
Attention !Before performing any work on the equipment, pull the power
plug.
9.1
Cleaning
Keep the ventilation slots of the machine clean to prevent overheating of the engine.
Regularly clean the machine housing with a soft cloth, preferably after each use.
Keep the ventilation slots free from dust and dirt.
If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.
9.2
Checking and replacing the carbon brushes
The carbon brushes must be checked on a regular basis.
In case of wear, replace both carbon brushes at the same time.
Mount the carbon brush holders.
After mounting new carbon brushes, let the machine run at no load for 15 minutes.
Use only the correct type of carbon brushes.
9.3
Connecting cable and mains plug
If the connecting cable (or mains plug) is damaged, it must be replaced. Replacement of the
connecting cable should only be carried out by a qualified specialist (qualified electrician).
10 TECHNICAL DATA
Mains voltage /frequency
230V ~ 50Hz
Power rating
1200 W
No load speed
500 m/min
Belt size
100 x 610 mm
11 NOISE
Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
90 dB(A)
Acoustic power level LwA
104 dB(A)
ATTENTION! Wear hearing protection when sound pressure is over 85
dB(A).
aw (Vibration) :
3.1 m/s²
K = 1.5 m/s²
