POWE10030
EN
Copyright © 2020 VARO
P a g e
|
6
www.varo.com
▪
Turn upper ring
A
anticlockwise with the other hand until the drill chuck opening is large
enough to accept the tool.
▪
Insert the drill or the screwdriver bit into the drill chuck.
▪
Turn ring
B
clockwise until the tool is snapped into lock place and clamped tightly.
▪
Remove the tool in the opposite way.
7.2
Switching on/off (Fig. 1)
▪
Connect the plug to the power supply. The power-on indicator (9) is illumed until the tool
disconnect from the power mains.
▪
To start the tool by squeezing the ON/OFF switch (4).
▪
Release the ON/OFF switch to stop the tool.
▪
If you press the lock-on button (6) while the ON/OFF switch is depressed, the ON/OFF
switch is kept in the operating position.
▪
To release the ON/OFF switch (4) and turn the tool off.
7.3
Forward/reverse lever (Fig. 2)
▪
The forward/reverse lever (3) is to determine the rotation direction of the chuck.
▪
To select forward rotation, release the ON/OFF switch (4) and push the forward/reverse
lever to right (R) side of the tool. To select reverse rotation, push the lever to left (L) side
of the tool.
NOTE: When changing the position of the lever, be sure the ON/OFF switch
is released and the motor is stationary.
7.4
Variable speed (Fig. 3)
This tool has a
speed control dial (5) that delivers higher speed by turning to the “
+
” direction,
and delivers lower speed by turning to “
-
”direction.
7.5
Drill and impact mode selector (Fig. 4)
The
drill and impact mode selector is on the top of this impact drill.
▪
Push t
he button of drill /impact mode selector (2) to the “
” to select the drill/impact mode
of action.
▪
Push the button of drill/impact mode selector to the drill position “ ” to select the drill mode
of action.
The
drill and impact mode selector is on the top of this impact drill.
7.6
Auxiliary handle (Fig. 5)
The auxiliary handle (7) will provide additional control, support and guidance for the drill.
▪
Slide the holder of the side grip over the drill chuck on the machine.
▪
Turn the side grip in the required position and tighten it firmly.
7.7
Depth gauge (Fig. 6)
The depth stop is used to limit the maximum drilling depth.
▪
Loosen the side grip (7).
▪
Insert the depth stop (8) in the hole in the holder of the side grip.
▪
Adjust the depth stop to the required drilling depth.
▪
Tighten the side grip firmly.
7.8
For proper operations
▪
Hold the drill with your first two fingers on the ON/OFF switch (4).
▪
Use the auxiliary handle subassembly (7) where possible to gain extra control and to
prevent fatigue.
▪
For wood, use twist drill bits, spade bits power auger bits, or hole saw.
▪
For metal use high seed steel twist drill bits or hole saws.