POW2040
EN
Copyright © 2015 VARO
P a g e
|
5
www.varo.com
Make sure that the workpiece is sufficiently supported or clamped. Keep your hands away
from the surface to be cut.
Always wear safety goggles and hearing protection. If desired or required also use another
kind of protection like for example an apron or helmet.
Ensure that mounted wheels and points are fitted in accordance with th
e manufacturer’s
instructions.
Ensure that blotters are used when they are provided with the bonded abrasive product
and when they are required.
If a guard is supplied with the tool never use the tool without such a guard.
For tools intended to be fitted with threaded hole wheel, ensure that the thread in the
wheel is long enough to accept the spindle length.
Ensure that ventilation openings are kept clear when working in dusty conditions. If it
should become nessesary to clear dust, first disconnect the tool from the mains supply
(use non metallic objects) and avoid damaging internal parts.
Though poor conditions of the electrical mains, shortly voltage drops can appear when
starting the equipment. This can influence other equipment (eq. blinking of a lamp). If the
mains-impedance Zmax <0.348 Ohm, such disturbances are not expected. (In case of
need, you may contact your local supply authority for further information.
7
ASSEMBLY
Prior to mounting an accessory always unplug the tool.
7.1
Mounting the side-handle
The side handle can be used for both left-hand and right hand control.
Fasten the side handle for left-hand operation on the right-hand side of the machine.
Fasten the side handle for right-hand operation on the left-hand side of the machine.
7.2
Mounting the guard (Fig.2)
Mount the guard before using the machine.
Place the guard (1) on the housing. Be aware that the notch of the guard falls across the
edge of the housing.
Fix the guard by screwing the bolt (2)
Screw on the flange nut (3)
The closed side of the guard always has to point in the
user’s direction.
Be aware the screw is tightened well enough. Check regularly if the screw
is still fixed.
7.3
Mounting a grinding disc (Fig.3)
Use grinding discs of the correct dimension. Use fibre reinforced grinding discs only. The
grinding disc must not touch the edge of the guard.
Remove the plug from the mains
Press the spindle lock and turn the spindle until it engages in the lock. Keep the spindle
lock pressed during this procedure.
Remove the flange nut (2) from the spindle using the spanner (1).
Position the grinding disc on the flange (3).
Place the flange nut on the spindle and tighten it using the spanner.
Release the spindle lock and check that the spindle is unlocked by rotating it.
