9
Filter Bag System Assembly
Note:
If your dust collection system includes the
canister kit, proceed to
Canister System
Assembly
on page 10.
1. Insert
a
hanger bracket
between
support bar
and collector housing (Figure 4).
2. Align holes and secure with two M8x20 hex
cap screws and two M8 flat washers outside
the housing, and two M8 flat washers and
two M8 hex nuts inside the housing. Hand
tighten only.
Figure 4
3. Make any needed adjustments to the
support bar
, then tighten the two upper and
two lower screws on the
support bar
with
13mm wrenches.
4. Insert
the
ring
(Figure 5) of the
collector bag
into the bottom of the housing at an angle.
Pull down on the collector bag to make sure
it “seats” on the inner lip of the housing.
5. Position the plastic window in front so that
you can easily see when collector bag is full.
6. Connect the
upper hanger
to the
hanger
support bar
(Figure 6).
7. Slide the loop of the
filter bag
over the hook
on the
upper hanger
and mount the hanger
assembly onto the
hanger bracket
(Figure
4). Rotate the hanger so that the hook at the
top points toward the front of the machine.
8.
Unroll the
retainer straps
(Figure 6).
CAUTION:
Retainer straps are coiled under
tension. Maintain a firm grip on each one
while unrolling it.
9. Thread
the
retainer strap
(Figure 6) through
the loops on the filter bag, and fasten it to
the collector housing, as shown in Figure 7.
Figure 5
Figure 6
Figure 7
Retainer strap
connection
The retainer strap
should be tight enough
to provide a good seal.
