Powermatic 60B, Instruction Manual & Parts List

Page: 10 / 44

10
2. Secure table to stand with three 3/8-16x2-3/8
bolts, six 3/8 flat washers, three 3/8 lock
washers and three 3/8 hex nuts (Fig. 6).
Tighten with 9/16" wrench.
ALIGNING PULLEYS
Place a straight edge against the motor pulley
and cutterhead pulley to make sure they are
aligned. If adjustment is necessary, loosen the set
screws in the motor pulley, and slide it as needed
until alignment is achieved. Re-tighten set
screws.
MOUNTING DRIVE BELT
1. Place the belt into the groove of the
cutterhead pulley.
2. Reach through the opening on the side of
the stand with a 12mm wrench, and loosen
the nuts on the motor mount screws (Fig. 7).
3. Lift up on the motor to provide slack, and
place the lower end of the drive belt into the
motor pulley groove.
4.
Let the motor slide down and push down on
it until the belt is properly tensioned. NOTE:
There should be only moderate deflection in
the belt midway between the pulleys when
using light finger pressure (Fig. 8).
5. Tighten the four hex nuts through the chip
chute opening.