PowerLift SBL460, Owner'S Manual, Page: 24 / 66

S T E P
9
Be careful to assemble all components
in the sequence they are presented.
A. Open hardware package labeled “Step 9 & Step 10”.
B. Align pivot point of right press handle (AV) with pivot hole of right press beam (AP).
Slide the 2 3/8” pivot shaft (AU) thru press beam and press handle. Secure in place using:
two 51 (flat washer 10mm x 30mm)
two 55 (spring lock washer 10mm)
two 40 (round allen head 10mm x 20mm full thread bolt)
C. Repeat the above to install left press handle (AT) in to left press beam (AN).
D. Install Olympic adapter sleeves (4) on to both press beams as shown using:
two 51 (flat washer 10mm x 30mm)
two 55 (spring lock washer 10mm)
two 40 (round allen head 10mm x 25mm full thread bolt)
You should wrench tighten these bolts now.
two 5 (round plastic ball-end caps 2”)
two 21 (rubber donut)
You should now wrench tighten all bolts. Do NOT wrench tighten any pad bolts.
E. You should now tighten the two small allen head set screws in each of the pillow block bearings (22).
23
mm
Inch
Congratulations! You are done. After assembly, you should check all functions to ensure correct
operation. If you experience problems, first recheck the assembly instructions to locate any
possible errors made during assembly. If you are unable to correct the problem, call the dealer
from whom you purchased the machine or call 1-800-556-3113 for the dealer nearest you.
Note: If any bolts seem to loosen periodically, use Loctite 242 for a long-term cure.