Powerhorse M1156, Owner'S Manual

Page: 36 / 40

Assembly Instructions
36
Step 10

Attach the Cylinder Hoses to the Control
Valve.

Use Teflon Tape on Hose Threads.

Attach the Short Cylinder Hose to the
Control Valve Port marked “A” in the
figure.

Attach the Long Cylinder Hose to the
Control Valve Port marked “B” in the
figure.
* Pump Hose not shown in figure for clarity
Step 11

Route the Cylinder Hoses through the Hose
Guide and then through the opening
between the Beam Assembly and Hydraulic
Tank Assembly, running the Cylinder Hoses
along the bottom of the Beam Assembly
toward the Hitch end of the unit.

Install the Zip Tie around the pump and
cylinder hoses.
Long hose
Short hose
Control valve
A B
Cylinder
hoses
Zip tie
Hose guide
Beam
assembly
WARNING

All Hoses should be routed and secured
outside of the beam slide zone.

Note: Injury can occur if beam slide comes
into contact with any hose.
Beam Slide
Zone
Hydraulic Hoses
Pump hose