Page 24 of 35
Removing Oil
The oil must be drained from the Oil Drain Plug. (See figure 2.)
1. Remove the dipstick (C)
2. Please an approved container below the oil drain plug.
3. Remove the Oil drain plug (D) and allow oil to the drain into the approved container.
4. Install Oil drain plug (D) and wrench tighten.
How to Service the Fuse-see figure 3 (if applicable)
⚠
WARNING
Never use a fuse with a rating greater than the one originally equipped with the engine. Serious
damage to the electrical system or a fire could result.
1. Remove the 6x12mm screw from the rear cover of the engine switch box.
2. Remove the fuse cover, then pull out and inspect the fuse.
3. Reinstall the rear cover. Install the 6x12mm screw and tighten.
figure3 figure4
How to Service the Battery -see figure 4 (if applicable)
⚠
WARNING
Be careful not to connect the battery in reverse polarity, as this will short circuit the battery charging
system.
Note
: Use a 12-volt battery with an ampere-hour rating of at least 18 Ah.
1. Connect the positive (+) cable to the starter solenoid terminal
.
2. Connect the negative (-) cable to an engine mounting bolt or other good engine ground
connection.
3. Connect the positive (+) cable to the positive (+) terminal.
4. Connect the negative (-) cable to the negative (-) terminal.
Summary of Contents for 750122
Page 8: ...Page 8 of 35 Safety Labels...
Page 27: ...Page 27 of 35 Parts Diagram...
