PowerGrip YG-2, Operation Manual

Page: 10 / 12

2
10
CONFIGURATION MENU / MEASUREMENT MODE
S
Sensor mode:
0 – only brightness by bringing the hand close
1
– brightness by bringing the hand close +
first group activation using one finger touch +
second group activation by two fingers touch
2
– brightness by bringing the hand close +
second group activation by two and one fingers
3 – brightness by bringing the hand close +
third group activation by one finger touch +
second group by two fingers
4
– brightness by bringing the hand close +
change of measurement mode by one finger touch (see
Measurement mode) and the second group activation by
two fingers touch
To save the settings you need to go through the menu to the
end.
MEASUREMENT MODE
To switch to measurement mode, the fourth sensor mode should be
chosen in the menu (see configuration menu), and then, by touch-
ing the screen with one finger in the operating mode one can
change the displayed information.
Three types of values are displayed:
1. Supply voltage
2. .ХХ – supplying network frequency deviation by one and
two decimal places of 50 Hz. It characterizes the power
plant workload.
3. H00 – percent of sinusoid cut. It closely matches harmonic
distortions of sinusoidal wave in the network. It characteriz-
es the electrical wiring workload.