Installing a Lighting Surge Protector
If your system includes a
Lightning Surge Protector
, connect it between the outside
antenna and the coax cable to the booster. Insert an 8- to 10-gauge solid copper ground
wire (not included) into the eyelet of the surge protector and crimp with pliers. Run the
ground wire outside the house to an 8-foot solid copper ground rod (not included).
Installing a Dome Antenna
If your system includes a dome antenna, install it in a location where you have access
above the ceiling. Cut a ¾-inch hole in the ceiling and insert the antenna’s mounting post
and pigtail connector cable through the hole. Twist the mounting nut onto the top of the
post until the antenna is flush with the ceiling. Do not overtighten. Connect the pigtail
cable to a coax cable that runs to the booster.
How to Install Two or More Inside Antennas
If your system includes two or more inside dome or panel antennas, attach the short (typically 2-foot) jumper cable to the
Inside port of the booster. Connect the splitter to the other end of the jumper cable. Connect coax cables to the opposite
end of the splitter and run one to each inside antenna.
Instructions
continued
:
Mounting Nut
Antenna
Ceiling
Coax Cable
435-634-6800 | www.PowerfulSignal.com
Signal Booster
2-Way Splitter
Cable to Outside Antenna
Inside Antennas
