10 GB/IE
Push the ON / SET button
4
to switch the
device on.
Before making the first measurement, use a test aid
1
to verify the device is working properly. The
test aid has four measuring points marked B and T.
Push the measuring pins
2
into measuring point
B. All gauge marks in the display
3
will be-
gin to flash.
Now press the measuring pins into measuring
points T. The gauge marks in the display should
read 19 % (+ / - 1 %).
The device is ready for use if both tests return
the specified values.
Push the measuring pins into the material you
wish to test. The gauge marks in the display
will show the moisture content.
-symbol, left: use to read the measurement
for firewood, cardboard and construction wood.
-symbol, right: use to read the measurement
of mortar, concrete and plaster.
Note:
the gauge marks will start flashing if
the measurement exceeds the maximum values
of 2 % resp. 44 %.
Note:
perform comparison measurements in
several different locations to minimize measur-
ing errors.
Temperature display
Note:
the temperature will be displayed in the top
section of the display
3
.
Hold the ON / SET button
4
for three seconds to
switch between Celsius (°C) and Fahrenheit (°F).
LED torch
Hold the LED button
5
for three seconds to
switch on the LED torch
6
.
Summary of Contents for 109791
Page 3: ...A 1 2 3 4 5 6...
Page 4: ...B 8 7 9...
