WARNING:
To reduce the risk of injection or injury, only use the sur-
face cleaner on flat, horizontal surfaces. Never lift the
surface cleaner from the cleaning surface while operating
the pressure washer.
uSING the SuRfACe CleANeR
See Figure 5.
n
Attach the high pressure hose of your pressure washer
to the inlet plug on the surface cleaner’s trigger handle.
n
Connect the garden hose to your pressure washer and
start the pressure washer as described in your pressure
washer manual.
n
Walk slowly behind the cleaning deck, cleaning as you
go.
Note:
If striping or swirling occurs, slow your pace. If
striping or swirling continues, the surface cleaner skirt
bristles may be worn and in need of replacement.
CAutIoN:
Striking any raised obstacle while using the surface
cleaner will damage the unit. If contact does occur and
causes vibration when operating the pressure washer,
stop and replace the spray bar. Continuing to operate
the unit without replacing the spray bar could result in
serious injury or damage to the unit.
Note:
See figure 6 for the location of the spray bar.
Nozzle mAINteNANCe
See Figure 6.
Excessive pump pressure (a pulsing sensation felt while
squeezing the trigger) may be the result of a clogged or
dirty nozzle.
n
Turn off the pressure washer and shut off the water
supply. With the surface cleaner on the ground, pull trig-
ger to release water pressure.
n
Disconnect surface cleaner from high pressure hose.
n
Using a wrench (not provided), remove the nozzle from
the spray bar.
Note:
Never point the spray bar at your face.
n
Using a straightened paper clip or nozzle cleaning tool
(not provided), free any foreign materials clogging or
restricting the nozzle.
n
Using a garden hose, flush debris out of nozzle by back
flushing (running the water through the nozzle backwards
or from the outside to the inside).
Fig. 6
spray bar
teChtRoNIC INduStRIeS NoRth AmeRICA, INC.
Hwy 8
Pickens, SC 29671
1-866-340-3912
987000-575
5-8-09 (REV:01)
Fig. 5
n
Reconnect the nozzle to the spray bar and tighten se-
curely. After tightening, make sure the nozzle opening is
pointed in the same direction as the spray bar as shown
in figure 4.
n
Reconnect the high pressure hose to the spray wand.
n
Turn on the water supply and start the pressure washer.
ReplACemeNt pARtS
The following replacement parts may be ordered by calling
our customer service department at 1-866-340-3912:
Spray Nozzle .....................................................310534001
Brush Skirt .........................................................308445003
Inlet Plug ............................................................678212002
Spray Bar .......................................................... 310533001
nozzle
straightened
paper clip
