-09-
e) Binding the receiver to the transmitter
The receiver must be programmed to the transmitter’s GUID to ensure that it only
processes the signals from its own transmitter. This procedure causes the receiver
to store a code which is unique in the world. During the binding process the servos’
fail-safe positions are also stored. The
PowerBox Evolution Spektrum
offers two
types of “fail-safe”. The methods are the same for all Spektrum receivers:
a. Binding using the SmartSafe system
In this case all control surfaces remain in Hold mode in a fail-safe event, while the
throttle channel runs to Idle or the Off position:
- Check that the
PowerBox
is off, then insert the Bind plug into it.
- Switch the
PowerBox Evolution Spektrum
on: all three satellites should now
flash at a high rate.
- Hold the transmitter’s Bind button pressed in while you switch the transmitter on.
- Continue to hold the button pressed in until the LEDs on all the satellites glow
constantly.
- Disconnect the Bind plug.
