PowerBass XL-2205M, Owner'S Manual, Page: 14 / 28

REM (Remote Trigger)
This terminal must be connected to a sw12V source. Typically, remote turn-on leads are provided
at the source unit that will turn on and off the amplifier in correspondence with the source. If the source unit
does not have a remote turn-on lead, then a sw12V supply must be used, like the ACC, +12V.
Run a minimum of 18 gauge wire from the amplifier location to the source of the sw12V lead. If
possible, route this wire on the same side of the vehicle as your power cable. Connect the source remote
output to the wire. Go back to the amplifier and cut the wire to length. Loosen the screw terminal marked
REM on the amplifier using an Allen wrench. Insert the stripped (bare) portion of the wire into the terminal
and tighten the screw securely.
NOTE:
It is highly recommended that an Allen wrench is used to tighten the set screws
in the terminal blocks by hand and NOT a power drill. This will prevent stripping or other
possible damage to the amplifier.