CROSSOVER NETWORK INSTALLATION AND WIRING
Your PowerBass Autosound Component system contains two separate 2-way crossover networks. When
choosing a location to mount the crossovers, keep in mind they contain electronic parts which can be
damaged by moisture and dirt.
Correct wiring of the crossover is critical to avoid damage to the speakers and ensure true high fidelity
sound. Pay close attention to the markings on the crossover to be certain the correct speakers are in the
correct outlets as follows:
1) Connect the amplifier or head unit output to the crossover’s INPUT terminals.
2) Connect the terminals labeled WOOFER to the component midrange speaker.
3) Connect the terminals labeled TWEETER to the component tweeter set.
CAUTION: Care must be taken when adjusting the screws on the input terminals that fasten the speaker
wires to the crossover network. Make sure each connection is secure without over tightening. Use of
power tools to tighten these screws is not recommended as they can strip the screws and permanently
damage the input terminals.
+INPUT—
+WOOFER—
+TWEETER—
NOTE: BE SURE TO OBSERVE PROPER POLARITY WHEN CONNECTING SPEAKER WIRES TO THE
CROSSOVER NETWORK TERMINALS.
This manual is the exclusive property of PowerBass USA, Inc. Any reproduction of this manual, or use other than its intentions is
strictly prohibited without the express consent of PowerBass USA, Inc. Copyright 2009 PowerBass USA, Inc.