REM (Remote Trigger)
This terminal must be connected to a sw12V source. Typically, remote turn-on leads are provided
at the source unit that will turn on and off the amplifier in correspondence with the source. If there is not a
remote turn-on lead on the unit, then a sw12V supply must be used, like the ACC, +12V.
Run a minimum of 18 gauge wire from the amplifier location to the source of the sw12V lead. If
possible, route this wire on the same side of the vehicle as your power cable. Connect the source remote
output to the wire. Go back to the amplifier and cut the wire to length. Loosen the screw terminal marked REM
on the amplifier. Insert the stripped (bare) portion of the wire into the terminal and tighten the screw securely.
FUSE REQUIREMENTS
While the panel on your PowerBass amplifier incorporates one or more fuses, these do nothing to protect
the vehicle from a dangerous short circuit. It is absolutely vital that the main power lead to the amplifier(s)
in the system be fused within 18-inches (45cm) of the connection to the vehicle battery. The value of this
fuse (or circuit breaker) should be no greater than the sum of the fuses found on all of the equipment being
connected to that power wire.
11
NOTE:
It is highly recommended that a hand driver and NOT a power drill is used to
tighten the set screws on the terminal blocks. This will prevent stripping or other possible
damage to the amplifier.
