PowerBass ASA 00.2x, Owner'S Manual, Page: 3 / 24

TECHNICAL FEATURES
• Low Profile Aluminum Finned Heatsink
• PWM MOSFET Power Supplies for High Power Output and Best Stability into Low Impedance Loads
• Variable High Pass and Low Pass Electronic Crossover
• Soft Delay Remote Turn On/Off Circuit to Eliminating Pops and Clicks
• Fully Adjustable Bass EQ at 40Hz (18dB)
• Self Diagnostic Multi Protection Circuit with LED Status Indicator for; Impedance Over-load, Speaker
Short Circuit, Thermal Overheating, and DC Output.
• 2-ohm Stereo Stable (4-ohm Mono Bridgeable)
• Custom Tooled Speaker and Power Terminal Blocks
• Variable Gain Control
• Gain Control Port (for Optional Remote Control - model ASA-BASS sold separately)
• Low Level Line Inputs and Outputs
INSTALLATION EXPERIENCE
Installation of PowerBass mobile amplifiers requires detailed knowledge of electronics wiring and proper
speaker impedance. We strongly recommend installation by an authorized PowerBass dealer. This Own-
ers Manual only provides general installation and operation instructions. If you have any reservations
about your installation skills, please contact your local PowerBass dealer for assistance.
IMPORTANT : This amplifier is designed for operation in vehicles with 12-volt Negative ground
electrical systems only.
PREPARING FOR INSTALLATION
NOTE: The tools listed below may be required for basic installation
• An electric drill with bits
• Philips head and standard screwdrivers
• Wire strippers
• Crimping tool
• VOM (electronic volt ohm meter)
• Heat shrink tubing and heat gun
• Soldering iron
• Electronic (not Acid Core) Solder
3