22
Filling oil tank
i. Park the chainsaw on a level surface and keep the oil tank
cap face upward.
ii. Clean the area around the oil tank cap (2) and then open by
turning it counter clockwise.
iii. Fill the oil tank with saw chain oil until the oil tank is full..
Make sure that no dirt gets into the oil tank, so that the oil
nozzle does not clog up.
iv. Close and tighten the oil tank cover (2).
WARNING! The product is not filled with oil. It is essential
to fill the product with oil before using it! Never operate the
product without chain oil or with an empty oil tank, as this will
result in extensive damage to the product!
WARNING! Removing the battery pack before filling the oil
tank.
3
Installing or removing battery pack
i. Hold the tool and the battery pack firmly when installing
or removing the battery pack. Failure to hold the tool and
the battery pack firmly may cause them to slip off your
hands and result in damage to the tool and battery pack,
potentially causing a personal injury.
ii. Always switch off the tool before installing or removing the
battery pack.
iii. To remove battery pack, press the release button, and pull
out. To install the battery pack, align the tongue on the
battery pack with the groove in the housing and slip it into
place. Always insert it all the way until it locks in place with
a little click. If not, it may accidentally fall out of the tool,
causing injury to you or someone around you.
4
2
