Poweramp • Division of Systems,
LLC
• W194 N11481 McCormick Dr. • Germantown, WI 53022
800.643.5424 • fax: 262.255.4199 • www.
Loading
DockSystems.com
For comprehensive installation instructions read and understand the
Installation and Operation Manual.
PowerHold Installation Overview
A continuing product improvement process is in effect at Systems,
LLC
. We reserve the right to make product changes without prior notice.
Concrete Dock Face
(Standard installation)
Driveway Mount
(Recommended when dock face is unsuitable for PowerHold Mounting)
Cantilevered Dock
(For bumper projection >4” or cantilevered dock or Edge-of-Dock leveler)
48”
8” Min.
Driveway mount requires attachment to
a concrete drive greater than 8” thick.
For asphalt drive, pour 48”x48”x8”
(min.) concrete pad and include six (6)
3/4” dowels into foundation wall. Then
proceed with adhesive anchors or weld
plate embed.
Determine offset
then proceed with
“Driveway Mount”
instructions below.
20”
20”
Weld three sides of PowerHold back plate to the
optional embed mounting plate (Part #7953-0119)
with continuous 1/4” fillet weld.
5 1/4” minimum
To determine size offset required, take total effective
bumper projection (bumper size plus any cantilever) and
subtract 4”.
48”
8” Min.
Using back plate as a guide, drill six (6) holes
for wedge anchors (3/4”x 5 1/4” min.) (Kit
#2103-0003)
Wedge Anchors Method
Drive Embed Method
Wedge Anchors Method
Weld Plate Embed Method
36”
14”
Embed
Plate
located 2”
above grade
3/8”
Driveway Mount
Wall Mount
Dim. A
Offset Formula
Dim. A
Dim. B
Offset
Bumper Projection
Cantelever
4"
+ Dim B
6"
+ Dim B
-4" = Offset
10"
+ Dim B
15"
+ Dim B
Dim. B
Dim. A
Dim. B
Weld method
Properly locate and level the drive embed weld
plate (Part#7953-0132) in the drive approach.
Observe Cantilever conditions for proper
positioning. Weld restraint to embed plate with a
continuous ¼” filet weld.
(Kit #2103-0003)
Install six (6) 3/4” Dia. x 5 1/4”
min. wedge anchors at the base
of the PowerHold.
Dim. B
Dim. B
48”
For filler requirements from 1 ½”to
7 ½” use cantilever bracket #9414-
0054
weld to
embedded mounting plate (Part
#7953-0119)
For filler requirements for 8 3/4” to
13 3/4” use cantilever bracket
#9414-0055 and anchor cantilever
bracket to the dock face (3/4” Dia.
X 5 1/4” min.) (Kit #2103-0003) or
weld to embedded mounting
Plate (Part #7953-0119).
and anchor cantilever bracket
to the dock face or
