Fence Energizer Operation
See Page 9-13 for detailed instructions on connecting the Power
Wizard PW350B Electric Fence Energizer to your Power Wizard Por-
table Corral Kit.
INSTALLATION
STEP 1
Drive one pointed rod 8” to 12” into the ground at each corner,
approximately 30 feet apart, using the included drive cap to prevent
splintering. Enough polywire is supplied to build a 30-foot square,
2 strand corral.
A round corral is preferred by many horse enthusiasts. See Step 4 on
Page 6 for an illustration of this configuration.
POWER WIZARD PW350B
SPECIFICATIONS AND FUNCTIONS
The PW350B has an LED (light emitting diode) on the front of the unit.
When the energizer is running, the On/Off knob is used to set the pulse rate
and can be adjusted at any time. The LED flashes once for every pulse.
If the supply voltage drops below approximately 3.1V, the LED starts to
blink rapidly with weak light flashes. This indicates the battery is low.
TECHNICAL DATA
Power Source:
Internal 4 X 1.5V alkaline D-cell battery or
external 6 or 12 V battery
Current Consumption:
Approx. 20-40mA depending on operating
conditions
Pulse Rate:
20-60 pulses per minute (user adjustable)
Output Energy:
70-360 mJ depending on operating conditions
at 500 ohms
Operating Temperature:
14 to 122˚F (–10 to 50˚C)
POWER WIZARD PW350B
BATTERY LIFE TABLE
This table shows the
average battery life when using 4 D-cell alkaline
batteries. NOTE:
40 pulses per minute is a common setting.
NOTE: Battery life will be shortened at colder temperatures.
30’
30’
PW350B
3
weeks
4
weeks
5
weeks
6
weeks
9
weeks
60
50
40
30
Pulses Per Minute20
3
14
Drive Cap
See Figure A
below.
Figure A.
Drive cap, fiberglass post
and rubber mallet.
TROUBLESHOOTING
If fence voltage is less than 2000V, check these before calling service:
• Check that there are batteries in the energizer and they are inserted
correctly. Note the battery icons located on the inside of the top lid.
(see page 11 for correct installation of batteries)
• Disconnect energizer from fence and check energizer voltage only.
Voltage should be greater than 6000V. If less, batteries may be low.
• Check your ground rod installation.
• Check your connections to the energizer.
• Check your connections at the ground rod.
• Ensure that the energizer is on and flashing.
If you are still having problems, please call
Customer Service at (800) 866-2161
20
