Assembly
TM
3
• Pull firmly to separate the two black motor harness
connectors near the rear of the vehicle frame.
• Position the vehicle body on top of the vehicle frame.
• Fit each
motor harness connector
up through the
rectangular
opening in the vehicle body, one at a time.
• Fit the two halves of the
high speed hook-up con-
nector
through the
square
opening near the front of the
vehicle body.
1
• Position the tail light cover with the inside arrow
pointing upward.
• Fit the tail light cover on the back of the tail light.
• Insert two #8 x
1
/
2
" screws through the holes in the tail
light cover.
• Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
2
• Position the vehicle body upside down on a flat surface.
Square
Opening
Tail Light
Cover
Tail Light
Motor
Harness
Connectors
Vehicle Frame
Rear of
Vehicle
Vehicle
Body
Rectangular
Opening
High Speed
Hook-Up
Vehicle Body
Tail Light
#8 x
1
/
2
" Screw
#8 x
3
/
4
" Screw
#8 x
3
/
4
" Screw
F
Children can be harmed by small parts,
sharp edges and sharp points in the
vehicle’s unassembled state, or by electrical
items. Care should be taken in unpacking
and assembly of the vehicle. Children
should not handle parts, including the
battery, or help in assembly of the vehicle.
WARNING
• Fit the tail light on the outside of the rear fender as
shown. Make sure the holes in the rear fender and tail
light are aligned.
• Insert one #8 x
1
/
2
" screw through the hole near the end
of the fender in the vehicle body and into the tail light.
• Insert two #8 x
3
/
4
" screws through the remaining holes
in the vehicle body and into the tail light.
• Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
11
