4
• If the machine should start to vibrate abnormally,
stop the engine, disconnect the spark plug wire and
ground it against the engine.Inspect thoroughly for
damage. Repair any damage before starting and
operating.
• Disengage all control levers and stop engine before
you leave the operating (behind the handles).
• Wait until the auger /impeller comes to a complete
stop before unclogging the chute assembly, making
any adjustments, or inspections.
• Never put your hand in the discharge or collector
openings. Always use the dean-out tool provided to
unclog the discharge opening. Do not unclog chute
assembly while engine is running. Shut off engine
and remain behind handles until all moving parts
have stopped before unclogging.
• Use only attachments and accessories approved by
the manufacturer (e.g. wheel weights, tire chains,
cabs etc.).
• When staring engine, pull cord slowly until
resistance is felt, then pull rapidly, Rapid retraction
of starter cord (kickback) will pull hand and arm
toward engine faster than you can let go. Broken
bones, fractures, bruises or sprains could result.
• If situations occur which are not covered in this
manual, use care and good judgment contact
customer support for assistance.
Maintenance & Storage
• Never tamper with safety devices. Check their
proper operation regularly. Refer to the
maintenance and adjustment sections of manual.
• Before cleaning, repairing, or inspecting machine
disengage all control levers and stop the engine.
• Wait until the auger impeller come to a complete
stop. Disconnect the spark plug wire and ground
against the engine to prevent unintended starting.
• Check bolts and screws for proper tightness at
frequent intervals to keep the machine in safe
working condition. Also, visually inspect machine for
any damage.
• Do not change the engine governor setting or over-
speed the engine. The governor controls the
maximum safe operating speed of the engine.
• Snow thrower shave plates and skid shoes are
subject to wear and damage. For your safety
protection, frequently check all components and
replace with original equipment manufacturers
(OEM) parts only. Use of parts which do not meet
the original equipment specifications may lead to
improper performance and compromise safety.
• Check control levels periodically to verify they
engage and disengage properly and adjust, if
necessary. Refer to the adjustment section in this
operator's manual for instructions.
• Maintain or replace safety and instruction labels, as
necessary.
• Observe proper disposal laws and regulations for
gas, oil, etc. to protect the environment.
• Prior to storing, run machine a few minutes to clear
snow from machine and prevent freeze up of auger
impeller.
• Never store the machine or fuel container inside
where there is an open flame,spark or pilot light
such as water heater, furnace, clothes dryer etc.
• Always refer to the operator's manual for proper
instructions on off-season storage.
• Check fuel line, tank, cap and fittings frequently for
cracks or leaks. Replace if necessary.
• Do not crank engine with spark plug removed.
• Have the machine inspected annually by an
authorized service dealer to ensure that all
mechanical and safety systems are working
properly and do not worn excessively. Failure to do
so can result in accidents, injuries or death.
Do Not Modify The Engine
To avoid serious injury or death, do not modify
engine in any way. Tampering with the governor
setting can lead to a runaway engine and cause it
to operate at unsafe speeds. Never tamper with
factory setting of engine governor.
