C-MONSTER TOP SIDE PROGRAMMING
INSTRUCTIONS
Need help? Contact our Technical Support Team at
1 + 813.689.9932 Option 2
©2017 all rights reserved. Power-Pole Shallow Water Anchor U.S. Patent No. 6,041,730
Top Side Control Switch Functions – HPU (Hydraulic Pump Unit)
1.
Press and hold the PROGRAM button for 6 seconds until LED flashes
red and two chimes are heard followed by a single beep. (
FIG. 1
)
NOTE:
You are now in
Function 1
.
2.
Press the PROGRAM button to toggle through the remaining functions
below, until you reach the one you wish to adjust:
1 beep
= Set HPU as single, port or starboard side (see Function 1)
2 beeps
= Changes the speed of the standard key fob remote control (Figure 2)
3 beeps
= Up direction sensitivity adjustment – Controls the operation
of the Auto Up features. If the unit continues to run once retracted,
increase the sensitivity. If the unit stops running prematurely, decrease
the sensitivity. (
FIG. 2
)
4 beeps
= Down direction sensitivity adjustment – Controls the operation of the
Auto Down feature. If the unit turns off prematurely during deployment,
decrease the sensitivity. If the unit continuous to run once anchored, increase the sensitivity. (
FIG. 2
)
You can use the UP and DOWN buttons to change the settings, (NOTE: default settings are in the middle of the range).
Tone increases with level (1-10). (
FIG. 2
)
Highest tone level
10
9
8
7
6
Middle range tone level
5
4
3
2
Middle range tone level
1
Once you have made all desired setting changes, press and release the PROGRAM button to save your settings and exit
program mode. You will hear a series of beeps and the LED light will return to flashing green.
Programming
Button
Up Button
Down Button
Figure 1
Figure 2
Press UP
for higher
speed setting /
higher sensitivity
Press DOWN
for Lower speed /
lower sensitivity
