Power One PODS 16.48-16000 1940 HEX, Instruction Manual, Page: 57 / 170

Operation / Product description PCS 2 8-11
Document number: 036777.fm
Revision: B
Operation / Product description PCS 2
Figure 8-4 Communications menu
7. Select "9600" baud rate from the Port Setup menu ( Figure 8-5 ).
Figure 8-5 Port Setup Menu
8. Select "OK"
9. Choose "Direct Communication" from the Communications menu.
10. Enter Password (1234 by default).
11. See "Product description PowCom 3.17" for more information about using PowCom software
8.4.3 Boost charging
Open the "Select/Adjust" menu on the PCS 2.
Boost charging can be activated by three methods:
Manual boost charging - Choose "U2" in the reference menu for activating boost charging. (Return to
float charge manually by choosing "U1", or automatically after a pre-set time.)
Periodic boost charging - after a pre-set period boost charge will be automatically activated for a pre-set
time. Interval and boost time to be programmed (for example 4 hours every 3rd week).
Automatic boost charging - when during a mains failure the battery voltage falls below LEVEL t1 value, a
timer is started. When the mains return, the system will start an automatic boost. This will last a certain time
after the battery voltage reach LEVEL t2. This time will be multiplied with a factor, K. LEVEL t1, LEVEL t2
and the factor can all be set.