Power One PODS 16.48-16000 1940 HEX, Instruction Manual, Page: 38 / 170

6-12 PODS 16.48-16000 1940 HEX
Document number: 039160.fm
Revision: A
Installation guide
Figure 6-8 Connection of Symmetry (2 Block Measurement) and Temp. Sensor
Installing the Symmetry cabling and the battery temperature sensor:
1. Remove the green plug from each connector.
2. Strip the wires back approximately 10mm. Stranded wire may be soldered or covered with copper
ferrule if desired.
3. Insert wire into the correct positions in the green connector and tighten screw to clamp wire into
connector.
4. The wires are wound up and pre-routed with fastener strips on the cabinet sidewall. The cables must
be unwound and connected to the battery pole according to the
Figure 6-8 on page 6-12 .
6.2.9 Battery connection
The battery cables of the system are, if ordered, pre-connected to the systems battery breakers. The “+”
cable of each battery string is connected to the positive bus bar of the system, and the “-“ cable to the
negative battery breaker (separate for each string). Connect the other ends of the cables to the “-“ and “+”
terminals of the batteries.
Note! Fasten the cable lugs pointing upwards, as there is not enough space in the cabinet for sideways
installation.
-48V
0V
-36V
-24V
-12V
3
6
2
5
1
4
Batt. sym. 3
Batt. sym. 4
+
Red
T
Green
-
Blue
T
3
2
1
Temp. Probe 1
J2
-24V
3
6
2
5
1
4
Batt. sym. 1
Batt. sym. 2
J1
+
Red
T
Green
-
Blue
6
5
4
Temp. Probe 2
+
Red
T
Green
-
Blue
3
2
1
Temp. Probe 3
+
Red
T
Green
-
Blue
6
5
4
Temp. Probe 4
J4
J5
-24V
-24V
-24V
-48V
0V
-36V
-24V
-12V