Power One PODS 16.48-16000 1940 HEX, Instruction Manual, Page: 106 / 170

D-8 PODS 16.48-16000 1940 HEX
Document number: 038316.fm
Revision: B
BTS Breaker 50A 3-pole - Installation procedure
D.5 Mounting
Figure D-3 Mounted 50A 3-pole breaker with 150A capacity
1. Mount the kit according to Figure D-3
1.For 50A load breaker capacity mount the "end case" side of the signal cable harness on the middle
position on top of the breaker. Mount the negative load cable to the same slot on the breaker.
2.For 100A load breaker capacity mount the Connector 2xMCB (100A) for front terminal on top of the
breaker. Mount the "end case" side of the signal cable harness on the left most position on top of
the breaker. Mount the negative load cable to the front terminal for copper cables.
3.For 150A load breaker capacity mount the Connector 3xMCB (150A) for front terminal on top of the
breaker. Mount the "end case" side of the signal cable harness on the left most position on top of
the breaker. Mount the negative load cable to the front terminal for copper cables.
2. Tighten the upper screws on the breaker to a torque of 3,5 Nm.