18
12.
Engine Oil:
12.1.1.1. Remove the oil filter cap and check the oil.
12.1.1.2. Remove the drain plug and allow the oil to drain out. Ensure that the oil is drained into a
disposable container.
12.1.1.3. Remove the drain plug and allow the oil to drain out. Ensure that the oil is drained into a
disposable container.
12.1.1.4. Remove the drain plug and allow the oil to drain out. Ensure that the oil is drained into a
disposable container.
12.1.1.5. After all the oil is drained replace the drain plug and tighten sufficiently.
12.1.1.6. Replace the engine oil with the recommended type. Ensure that sufficient oil is added.
Ensure that this is done whilst the welder generator is on a flat secure surface.
12.2.
Spark Plug:
12.2.1. Ensure that the engine is switched off.
12.2.2. Remove the spark plug using a proper spark plug spanner.
12.2.3. Check the spark plug for carbon build up.
12.2.4. Clean the spark plug properly.
12.2.5. Check the spark plug gap is between 0.7mm and 0.8mm
12.2.6. If the spark plug is damaged and or very old and dirty we recommend that you replace it.
