Lubrication
NOTICE
All Bearings of your Splitter are sealed units and should have sufficient lubricant to last the
life of your machine with normal use.
Greasing the rack and Pinion
NOTICE
All the rack and pinion should be greased before every use.
Most problems are easy to fix. Consult the Troubleshooting Table below for common
problems and their solutions. If you continue to experience problems, contact the dealers in
your area.
WARNING
Before performing any maintenance procedure or inspection, stop the engine, wait five
minutes to allow all parts to cool. Disconnect the spark plug wire, keeping it away from the
spark plug.
Troubleshooting Table
SYMPTOM
POSSIBLE CAUSE
The engine won
’
t start.
(Please refer to the
engine user manual
for engine-specific
procedures.)
Ø
Is the ignition switch in the
“
ON
”
position?
Ø
Is the fuel shut-off valve on?
Ø
Are you using fresh, clean gas? If the gas is old, change it. Use
a fuel stabilizer if you keep gas longer than 30 days.
Ø
Is the spark plug clean? If the spark plug is dirty or cracked,
change it. If it
’
s oily, leave it out, hold a rag over the plug hole and
pull the recoil cord several times to blow out any oil in the
cylinder, then wipe off the plug and reinsert it.
The engine lacks power
or is not running
smoothly.
(Please refer to the
engine user manual
for engine-specific
procedures.)
Ø
Check that the Throttle Lever is in the
“
Run
”
position.
Ø
Is the air filter clean? If it
’
s dirty, change it following the
procedure in the engine manufacturer
’
s owner
’
s manual.
Ø
Is the spark plug clean? If it
’
s fouled or cracked, change it. If it
’
s
oily, leave it out, hold a rag over the plug hole and pull your
recoil cord several times to blow out any oil in the cylinder, then
wipe off the plug and reinsert it.
Ø
Are you using fresh, clean unleaded gas? If it
’
s old, change it. Use
a fuel stabilizer if you keep gas longer than 30 days.
Ø
Does your engine have the right amount of clean oil? If it
’
s dirty,
change it following the procedure in the engine manufacturer
’
s
owner
’
s manual.
Ø
Check the oil level and adjust as needed.
Engine smokes.
(Please refer to the
engine user manual
for engine-specific
procedures.)
Ø
Check the oil level and adjust as needed.
Ø
Check the air filter and clean or replace if needed.
Ø
You may be using the wrong oil
—
too light for the temperature.
Refer to your Engine Owner
’
s Manual for detailed information.
Ø
Clean the cooling fins if they
’
re dirty.
