background image

6

4

5

7

8

3

9

Product Overview

Introduction

Thank you for purchasing a Power Inspired Uninterruptible Power Supply. For further
information on this product or for support please visit www.powerinspired.com/vix3000/

Installation & Operation

  

NOTE: 

Before installation, please inspect the unit. Be sure that nothing inside 

the package is damaged.   

 

Placement & Storage Conditions 

Please place the UPS away from other units at least 20 cm to avoid interference. Do NOT 

operat

check the specs for the limitations.) 

      

 

 

6 hours 

 

Connect to Utility and Charging 

Plug in the AC input cord to the wall outlet. For the best results, 

suggest to charge the battery at least 6 hours before initial use. 

The unit charges its battery while connecting to the utility. 

 

Connect the Loads 

Plug in the loads to output receptacles on the rear panel of the UPS. Simply turn on the 

power switch of UPS unit, then devices connected to the UPS will be protected by UPS unit.

 

Connect Modem/Phone/Network for Surge Protection   

Connect a single modem/phone line into surge-protected “IN” outlet on the back panel of 

the UPS unit. Connect from “OUT” outlet to the computer with another phone line cable.   

 

Connect Communication Cable 

To allow for unattended UPS shutdown/start-up and status monitoring, connect the 

communication cable one end to the USB/RS-232 port and the other to the communication 

port of your PC. With the monitoring software installed, you can schedule UPS 

shutdown/start-up and monitor UPS status through PC. 

 

Turn On/Off the Unit 

Turn on the UPS unit by pressing the power switch. 

 

Turn off the UPS by pressing the power switch again.

 

 

Problem 

Possible Cause 

Solutions 

AC  input  is  not  connected 
well. 

Check if the input power 
connected to the mains. 

AC input is connected to the 
UPS output. 

Plug AC input power cord to AC input 
correctly. 

Battery backup time is 
shorter than nominal 
value. 

Batteries are not fully 
charged. 

Charge the batteries at least 6 hours 
and then check the capacity again. 
If the problem still persists, please 
consult your dealer. 

Batteries defect. 

Contact your dealer to replace the 
batteries. 

Warning or fault icon 
is shown and alarm is 
continuously 
sounding. 

Fan is locked or not working.  Check fans and notify your dealer. 

The UPS is overload. 

reconnecting devices, please verify 
the  total  loads  match  the  UPS 

 spec. 

Low battery icon is 
shown on the LCD 
screen. 

Low battery. 

Charge the UPS at least 6 hours. 

Troubleshooting

LCD blank / No LEDs
illuminated when
mains is normal

Power switch

LCD panel

Output receptacles
AC input
Circuit breaker / Fuse

Modem/Phone/Network surge 
protection

USB com port

1

2

3

4

5

Power switch

UPS status LED

AC mode: green lighting

LED Models

LCD Models

CAUTION: NEVER

 connect a laser printer or scanner to 

the UPS unit. This may cause the damage of the unit. 

Fault : Red lighting

1. Input information                  6. Battery capacity indicator 
2. Output information               7. Overload indicator
3. AC mode indicator                 8. Low battery indicator
4. Battery mode indicator          9. Fault indicator
5. Load level indicator

650V/850VA

2

4

5

1

1

2

3

4

5

1

4

2

5

1KVA

1.5KVA/2KVA

Reviews: