Power Hawk P-16, Safety & Instruction Manual, Page: 19 / 38

The Power Hawk
®
P-16 Rescue System Instruction Manual Page 17 of 34
2019-09
IMPORTANT:

When recharging, ALWAYS use the indicator lights on the charger to determine the status of the
battery, not the indicator on the power pack.

The charger is designed so that it will not overcharge or damage the battery if left plugged in. It is
recommended, however, that the charger be unplugged from the battery once fully charged and
stowed.

Charge at ambient temperatures ranging from 32 to 113°F (0 to 45°C).

Do not operate the P-16 Rescue Tool using the PWR-Li16C Battery Pack while connected to the
charger. The high amperage current draws of the P-16 Rescue Tool may cause the charger to blow a
fuse.

When stowed, disconnect the battery pack RED plug from the Controller Unit and install the plastic
protective cap over the live contacts.

Always have back-up power available for operating the P-16 Rescue Tool. It is recommended that you
have spare Power Hawk battery packs, however, other back-up power sources may be used such as;
12 volts DC automobile battery (using jumper cables Model JC4-16), 12 volts DC direct vehicle hook-up
(using Models VH4-4 Vehicle Harness Kit and EC4-16 extension cable), 12 Volts DC generator, and
12 Volts DC converted power supply, etc.
SLING PACK SETUP:
The SLPK-L680 Sling Pack provides comfortable
and super lightweight portability of the self-contained
power unit for the P-16 Rescue Tool. The pack
features a rear compartment for the PC-100
Controller Unit and a padded front compartment for
the PWR-Li16C Battery Pack. The cover flap is
secured using two adjustable straps with large snap
buckles. An additional wide strap is provided on top
of the cover to hold the CA-4M Power Cable. For
added stability, a waist belt can be found in the
Velcro pouch located on the back panel of the pack.
PC-100
Controller Unit
[Red Connector
on Left side]
PWR-Li16C
Battery Pack
Connect Red
Plugs to provide
power to the
P-16 Rescue Tool
[Stow disconnected
with cap in place]
Use the top
strap to secure
the CA-4M
Power Cable
Waist belt is
located in the
rear pouch.