• Double-ended Phillips
bit
• Hanging loop
• Air Regulator
• Bushing
IDENTIFICATION KEY
A.
Collet
B.
Hang Ring (not shown)
C.
Air Screwdriver
D.
Trigger
E.
Air Inlet
F.
Air Exhaust
G.
Air Regulator
H.
Dual Screwdriver Bit
I.
Male Air Plug
J.
Bushing
ASSEMBLY & INSTALLATION
1.
Attach the hang ring through the hole in
the tool's upper body.
2.
Remove the protective cap when you are
ready to install the air plug.
3.
Turn the air regulator knob fully in either
direction to seal the regulator in the off
position.
4.
Wrap the external threads of the air
regulator with sealant tape. Leave the leading threads unwrapped.
5.
Screw the air regulator into the tool's air inlet and tighten with a wrench
until snug.
INSTALL AIR COUPLER PLUG
Prepare a standard 1/4 in. NPT coupler plug (included) for use with your tool.
Fig. 1
9007824
PISTOL-GRIP AIR SCREWDRIVER
V1.0
www.princessauto.com / 1-800-665-8685
Page 8
