V1.0
16 Gauge Straight Finishing Air Nailer
8990863
Visit www.princessauto.com for more information
5
2. Do not use the tool if any parts are damage broken or
misplaced. Repair or replace the parts.
3. Do not drive fasteners into scaffolding, ladders, vehicles or
other similarly constructed items and materials.
4. Do not drive fasteners close to the edge of a work piece. This
may cause the work piece to split and for the fastener to fly free
or ricochet.
5. Do not drive fastener on top of nailed fastener.
6. Only operate tool when safety nose is in contact with the
work piece.
7. Do not operate tool without fasteners.
8. Never fire fasteners into the air or away from work piece.
AIR TOOL PRECAUTIONS
1. Use only clean and dry compressed air as a power source.
Contaminated or moist air will gradually damage the tool.
2. Install an in-line shutoff valve or regulator to allow immediate
control over the air supply in an emergency, even if a hose is
ruptured.
3. Discontinue tool use if it does not work properly or air is leaking.
Tag or mark the tool as ‘defective’ or ‘out of service’ until
repaired.
4.
Check the manufacturer’s maximum pressure rating for air tools
and accessories. Compressor outlet pressure must be
regulated to never exceed the maximum pressure rating of the
tool (see Specifications). Exceeding the maximum PSI rating
can create a bursting hazard, causing injury and property
damage.
5. Attach all accessories properly to the tool before connecting the
air supply. A loose accessory may detach or break during
operation.
6. Never use oxygen, combustible gas or any other bottled gas as
a power source. Any power source other than an
air compressor could cause an explosion and serious personal
injury.
7. Turn OFF the valve and discharge any remaining air pressure
after each use or before adjusting the tool.
