8934630
1,100 lb 65 x 26 in. Roll-Up Aluminum Ramp
V4.0
6
For technical questions call 1-800-665-8685
3. Temporary Installation - Adjust the
ramp’s angle at the first triangular
bracket, so the section and end plate
are flat on the surface. Position the
section and plate to completely
overlap the elevated surface.
4. Permanent Installation - Adjust only
the end plate when attaching to a
surface with the two plates (Fig. 2-1).
a. Fix each plate to the appropriate surface with two self-tapping screws
(Fig. 2-3).
b. Loosen the fixing screw (Fig. 2-2) on each side of the end plate (Fig. 2-4).
c. Position the ramp between the plates.
d. Insert each fixing screw through a plate’s slot and into the ramp. You
may need to slightly adjust the ramp and end plate position.
e. Tighten the fixing screws to secure the ramp.
CARE & MAINTENANCE
1. Maintain the tool with care. A tool in good condition is efficient, easier to
control and will have fewer problems.
2. Inspect the tool components periodically. Repair or replace damaged or
worn components. Only use identical replacement parts when servicing.
3. Maintain the tool’s labels and name plates. These carry important information.
If unreadable or missing, contact Princess Auto Ltd. for replacements.
WARNING! Only qualified service personnel should repair the tool. An
improperly repaired tool may present a hazard to the user and/or others.
DISPOSAL
Recycle a tool damaged beyond repair at the appropriate facility.
TROUBLESHOOTING
Visit a Princess Auto Ltd. location for a solution if the tool does not function
properly or parts are missing. If unable to do so, have a qualified technician
service the tool.
Fig. 2
