8821811
Adjustable Shop Stool with Backrest
V4.0
4
For technical questions call 1-800-665-8685
SPECIFIC SAFETY PRECAUTIONS
WARNING! DO NOT let comfort or familiarity with product (gained from
repeated use) replace strict adherence to the tool safety rules. If you use
this tool unsafely or incorrectly, you can suffer serious personal injury.
1. Use the correct tool for the job. This tool was designed for a specific function.
Do not modify or alter this tool or use it for an unintended purpose.
2. Do not use the tool if any parts are damage broken or misplaced. Repair or
replace the parts.
3. Do not exceed the rated load capacity.
4. Do not use the stool as a step stool.
UNPACKING
WARNING! Do not operate the tool if any part is missing. Replace the
missing part before operating. Failure to do so could result in a malfunction
and personal injury.
Remove the parts and accessories from the packaging and inspect for damage.
Make sure that all items in the parts list are included.
ASSEMBLY & INSTALLATION
Numbered references in parenthesis (#1) refer to the included Parts List.
1. Place a leg (#11) into a groove on the connector (#10). Insert an M6 hex
bolt (#5) down through the connector and leg.
2. Align the matching bolt hole in the connector plate with the bolt and push it
upward until the curved surface fits over the leg.
3. Secure loosely with an M6 locking nut (#8).
4. Insert each of the other legs into the openings created by the connector
and connector plate. Align the bolt holes and drop an M6 hex bolt through
all three parts. Secure each with a locking nut. Do not tighten at this point.
5. Fit the large ring (#12) inside the four legs. Align both a leg and ring bolt
hole. Insert an M6 bolt (#9) through the leg and ring. Loosely secure with
an M6 locking nut. Repeat with the other three legs.
