V4.0
Portable Lumber Mill
8726325
Visit www.princessauto.com for more information
5
ASSEMBLY & INSTALLATION
Numbered references in parenthesis (#1) refer to the included Parts List.
Tighten all nuts finger tight until ready to secure in place.
ASSEMBLE THE FRAME
1. Place both thickness rails (#10) down on a flat surface with the slots facing
up. Slide a carriage bolt (#9) into each slot to the midpoint.
2. Slide two carriage bolts into the slot of the on/off guide bar (#19). Place the
bar between both thickness rails and align all four carriage bolts (Fig. 1).
3. Place the tie bar (#17) over all four carriage bolts. Place a flat washer (#7)
over the two bolts that are furthest from you. Secure the inner bolt with an
M8 hex nut (#6) and tighten. Secure the outer bolt with a coupling nut
(#15) that is hand-tight (Fig. 2).
4. Place the handle (#25) onto the two bolts closest to you. The handle is
positioned between the two thickness rails. Place a lock washer (#23) over
each bolt end. Secure
the inner bolt with an
M8 hex nut (#6) and
tighten. Secure the
outer bolt with a
coupling nut (#15) that
is hand-tight (Fig. 3).
5. Slide a carriage bolt
(#9) into the slot in the left side of each thickness rail
(#10). Place an end bracket (#8) over the bolts with
the side flush to the thickness rail’s outer edge and the
flat bottom on the inside. Secure each bolt with a flat
washer (#7) and a hex nut (#6) (Fig. 4).
6. Attach the end bracket on the right side following the instructions in
Step 5. An exception is the end bracket will have the bottom flush with the
outer edge of the thickness rail and the side facing towards the inside.
7. Use a square angle, such as a roofer’s square, to square the inner side of
the thickness rails with the left bracket. Once they are square, carefully
tighten to secure the end in place. Repeat this process on the right side.
The result should be a rigid platform that is correctly squared.
Fig. 1
Fig. 2
Fig. 3
Fig. 4
