8717761
4,000 lb 12V DC A-Frame Trailer Jack
V4.0
10
For technical questions call 1-800-665-8685
4. Moving the towing vehicle away from the trailer’s hitch receiver.
5. Level the trailer by pressing the extend/retract switch to raise or lower the
jack. It is level once the bubble level is centered.
HITCHING THE TRAILER
1. Press the extend/retract switch to raise the trailer’s hitch receiver above the
level of the towing vehicle’s hitch.
2. Align the towing vehicle’s hitch with the trailer hitch receiver.
3. Press the extend/retract switch to lower the trailer hitch receiver onto the
towing vehicle hitch. Secure the hitch receiver once seated.
WARNING! The hitch receiver must be properly aligned and seated before
retracting the leg fully to prevent it from slipping off the hitch and causing
an injury to yourself or bystanders.
MANUAL OVERRIDE
A loss of power may require you to raise and lower the trailer using the manual
crank (L).
1. Remove the crank cap (G) and set aside.
2. Insert the manual crank onto the shaft in the housing.
3. Crank counterclockwise to extend the leg. Crank clockwise to retract the
leg. Follow the directions for hitching or unhitching the trailer.
4. Replace the crank cap when done and store the crank.
CARE & MAINTENANCE
1. Maintain the device with care. A device in good condition is efficient, easier
to control and will have fewer problems.
2. Inspect the device components periodically. Repair or replace damaged or
worn components. Only use identical replacement parts when servicing.
3. Follow instructions for lubricating and changing accessories.
4. Only use accessories intended for use with this device.
5. The jack’s motor is sealed and maintenance-free.
